Monday, February 22, 2010

Electric shock injury pictures

I found these pictures of electrical injuries from one of the NIOSH websites. They were classified as in public domain and free for re-publishing.

So I put them here for those whose need them but have no time or the Internet skills to go around digging inside those massive websites themselves.

Picture 1 - Entrance Wound






===================================

====================================

When an electric shock happens, the current enter the body at one point of contact and then leave the body at another point.
Therefore, two points of contact on the body are required for the electric shock to occur.
The two contacts will complete the electrical circuit, which will allow the shock current to flow through. (Read the post, Most basic principles of house electricity, to know the basics of how this works.)

At each of the points of contact, there is a resistance to the flow of current. The human body itself also presents resistance but this is normally low compared to the resistances at the two points of contact.
Just like the resistance in the filament of an electric bulb causes the filament to heat up, the resistances at these two locations caused the flow of the shock current to be converted into heat, which resulted in the severe burns that you see in Picture 1.

What the image in Picture 1 shows is the burn injury on the body at the location where the shock current flows in. The dark spot in the center of the wound is the entrance point.
This man was lucky. The shock current narrowly missed his spinal cord.

Picture 2 shows the injuries where the current leaves the body. Usually this is under the feet where they touch the ground.
The magnitude of the current when it enters the body is the same as when it leaves the body. If both feet touch the ground at the moment of the shock, then it is the total of the exiting currents at both feet.

In the case of Picture 2, it did not say whether both feet were injured. The foot shown here suffered massive internal injuries, that is not visible in the picture here. However, it was so bad that the foot had to be amputated a few days later.

Picture 2 – Exit wound


Picture 3 – Arc or flash burn



Don’t be there if you are not supposed to be there.
That is what I usually say to bystanders who hang around to witness the energization of a newly completed electrical system. It is always dangerous to be anywhere near the place because one of the most common types of accident there is electrical explosions.

The image in Picture 3 is one example of injuries from electrical explosions.
The NIOSH site said that man was near an electrical panel when the accident happened. He did not touch the electrical panel.

However, the electricity arched through the air. An example of electric arcs through the air is what we call lightning strikes.
Surprised? So you can consider this an injury from an extremely small lightning strike.

The man happened to be in the path of the arcing electrical current, so the current punched into his body. You may wonder why the injury is located at the armpit. That is because there were perspiration on his body at the time and perspirations are very conductive. So his armpit presented a very conductive (and therefore “very attractive”) path for the electric arc current.

Picture 4 - Thermal Contact Burns



Electric current not only heats up electrical wires that burn houses. If and when it travels through a human body, the points of contact where it enters and leaves the body can generate enough heat (due to skin contact resistances) to cause fire and burns the victim’s clothes.

That was what happened to the victim in this picture. The current exited the victim’s body at the knee. It caused fire at the skin there, which then catches his clothing and burned his upper leg.

Picture 5 – Internal injuries



This is an example of an electric tool accident. The worker was shocked by the electric tool he was holding. You can see from the picture the thermal burn injury at the entry point of the shock current.

However, the wound was even more severe that what can be seen here. Massive internal tissue damages have occurred that subsequently caused severe swelling to the hand.

The swelling usually peaks 24 – 72 hours after the electric shock. In this case, the hospital needed to cut open the skin on the arm in order to relieve the pressure that resulted from the swelling, which could have damaged nerves and blood vessels. This image in Picture 6 below was after the skin was cut open a few days later.

Picture 6 – A few days later



Picture 7 - Involuntary Muscle Contraction



This worker was working above overhead electrical cables. For some reasons he fell and grabbed the bare cables in order to save himself. The resulting electric shock mummified his first two fingers, which later had to be removed.

The acute angle of the wrist was caused by the burning of the tendons, which had contracted, drawing the hand with them.

Browse around other posts that I sent to this blog. You will find pictures of “bad electrical installations” that can lead to accidents and electrical injuries shown by the above pictures.

How much shock current does it take to cause the above injuries?

Keep on reading.

I have collected some data from the websites of relevant authorities, which you can see below.

Effects of the electric shocks

Listed below are the effects of electric shocks starting from the lowest amount of current flow to the highest for a duration of one second at typical household voltages.

1 mA - A normal person will feel a slight tingling sensation.

5 mA - A light shock will be felt, but most persons will be able to “let go”. Not a painful feeling, but definitely disturbing. However, a strong reflexive movement by the victim can cause further accidents and other type of injuries.

6 to 30 mA - The victim can be paralyzed, or the muscles will freeze (will not be able to release a tool, wire, or other object

Painful, and my not be possible to let go.

At high voltage (above 600 Volt, this current can already cause severe burns)

Women start to suffer the effect at lover current levels (6-26mA), while men can sustain until a bit higher (10 to 30 mA)

30 mA - Will cause respiratory paralysis
(The victim stops breathing for a period of time)

30 mA - This is the most sensitive rating of Earth Leakage Circuit Breakers (ELCB) normally installed in residential home in this country.

50 to 150 mA - The victim get an extremely painful shock.
The breathing stops (respiratory arrest).
Severe muscle contraction: flexor muscles may cause holding on, extensor muscles may cause intense pushing away.
Death is possible.

(At 75 mili-Ampere and above – The victim undergo ventricular fibrillation (very rapid, ineffective heartbeat). This condition can cause death within a few minutes. The only way to save the victim is by a special device called defibrillator.)

1 A and above - Uneven heartbeats occurs (Ventricular fibrillation).
The muscles will contract.
Damage to the nerves.
Death is likely.

4 A - The victim gets heart paralysis, which means the heart stops pumping.

(Highlight: How much is 4 amperes? If you connect a 1KW portable space heater to a wall socket outlet, and your house supply from the electricity company is 240 Volt, then that’s about 4.1 amperes running inside the wires from the socket to the space heater.)

5 A and above - Human tissues get burned.

10 A and above - Cardiac arrest and severe burns.
Death is probable.

Note: The above medical data has been obtained from the National
Institute for Occupational Safety and Health (NIOSH)

13 A - The lowest current a typical plug fuse will blow in a socket – plug supply connection.

15 A - Lowest level of current a normal circuit breaker or fuse will trip at a home distribution board, or a house electrical panel.
Further explanations on the electric shock injuries
The higher the current, the longer the time of the shock current, the more severe the injuries

(a) As you can see above, the higher the current that flow through a human body, and the longer it flows, the more serious the injuries.

If the shock is short in duration, it may only be painful. A longer shock (lasting a few seconds) could be fatal if the level of current is high enough to cause the heart to go into ventricular fibrillation.

100 mili-ampere current flow (that is one tenth of an ampere, or 0.1 Ampere) through the body will kill a person in just 2 seconds. Maybe he does not die immediately, but death is almost certain after sustaining 100 mA for 2 seconds.

(b) A person can only withstand less that 10 mili-amperes and still have control of his arm muscles. Beyond that, he no longer has control over his arms. That is the reason he cannot let go of the faulty tool he is holding (the hand may even tighten the grip on the electric tool), resulting in longer flow of shock current through the body thereby making the injuries more serious.

This situation when prolonged will lead to respiratory paralysis (the muscles that control breathing cannot move.)

That is part of the reason for the requirements to have install Earth Leakage Circuit Breakers (ELCB) for circuit supplying electrical tools. The ELCB can detect very small amount of leaked electrical current and trip that circuit within a fraction of a second thereby saving lives.

A severe shock can cause much more damage to the body than is visible. A person may suffer internal bleeding and destruction of tissues, nerves, and muscles.
Sometimes the hidden injuries caused by electrical shock result in a delayed death.
If a shock current is maintained long enough at a relatively high current, death is probably not avoidable.
But if somehow the contact area to the electrified object is broken fast enough and the victim’s heart has not yet been damaged, his normal heartbeat may return, even though this type of recovery is rare.

The severity of injuries depends on which part of the body does the shock current flow through

The most serious effect is when the current flow through the heart.
If a live wire accidentally touches the body by contact at the head, the nervous system will be severely damaged.
If during the accident the victim’s right hand touches the LIVE wire, while the left hand is holding the metal casing of the washing machine, the electrical current will flow through the chest. Then the lungs and heart will probably be injured.

Of course how severe will also depend of how many mili-amperes and how long the shock current flows.

If the current only flow through the arm portion, then the injuries can be as bad as the arm coming off while the victim still survive (not dead). There have been actual cases like these in high voltage accidents.

If the current does go through the chest, the person will almost surely be electrocuted.
A large number of serious electrical injuries involve current passing from the hands to the feet. Such a path involves both the heart and lungs.

This type of shock is often fatal.

A higher skin resistance will lower the shock current.

(a) Again the current is inversely proportional to the resistance. If the victim’s body is dry, then the shock current through his body will be lower. Then the injury will be less severe.

The resistance of a dry skin is can be 100,000 ohm or more. While that of a wet skin is only approximately 1,000 ohm.

At 600 volts, the dry skin resistance will only allow 6 mA at the most, while the wet skin can allow 600 mA to flow through the body.

Compare this to the list of injuries above and you can appreciate the extreme importance of dryness in the effort to avoid electrical shock.

Even at 240 volt, the wet skin will allow 240 mA to flow through the body, making very severe injuries and even death possible.

(b) Other than wet skin, wet working conditions will also have the same effect because they can make the skin wet and reduce resistance. Likewise, a damaged or broken skin.

(c) The resistance will also be reduced in direct proportion of the cross-sectional area of the path current. This means that when the contact made to an electrified object with an applied force as opposed to touching it with the tip of the fingers, the contact area will be larger. Therefore, the resistance to the current flow will be lower and the shock current will be higher.

Very Low Voltage also can kill
(a) The severity of the injury can increase the longer the victim is exposed to the shock current. Because of that, even low voltages can be extremely dangerous because the degree of injury depends not only on the amount of current but also on the length of time the body is in contact with the circuit.

Some victims have stopped breathing when shocked with currents from voltages as low as 49 volts.

For example, a shock current of 100 mA applied for 3 seconds can cause injuries as severe as a current of 900 mA applied for a fraction of a second.
(b) The victim’s muscle structure also plays a factor. People with less muscle tissue are typically affected at lower current levels.

The higher the voltage, the more serious the injuries.

(a) A current flow is directly proportional to the voltage supplying the current. That is why the higher the voltage, the higher the shock current flowing through the victim’s body. Therefore, the injuries will be more severe.

(b) At high voltage (i.e. 600 volts), the shock current can be as high as 4 amps. That amount of shock current will damage the hearts and other internal organs. In addition, internal blood vessels may clot, and the nerves in the area where the skin touches the electrified object may be damaged.

(c) High voltages can also cause severe tissue burns. A strong shock at the limb can cause the limb to come off.

Higher voltage can cause further accidents, therefore additional non-electrical injuries.

(a) Sometimes high voltages can lead to additional injuries. High voltages cause violent muscular contractions. The victim may lose his balance and fall, which can cause further injury or even death if he falls into machinery that can crush him.

(b) Bones can be fractured as a result from extreme muscle contractions during the shock, or cause by falling from working height.

You can see installation conditions that can lead to these injuries. Visit Temporary electrical installation pictures; Electric panel installation pictures; Multi storey building electric closets; Electrical installation pictures.

Copyright http://electricalinstallationwiringpicture.blogspot.com Electric shock injury pictures

No comments: